XDS-IP News & Updates

Adjusting XDS audio port volume levels

Jan 9, 2020

To adjust your audio port volume levels, log into your XDS-IP receiver via the IP address using the following credentials:

Username: ADMIN
Password: flash!

Under the ‘General’ tab, click on ‘Console’ and you will see the ‘Hudson>’ prompt.

Typing DSP VOL will show the current audio port levels with 255 being the highest and 0 being the lowest (255 is the default setting).

To lower the volume on Port A, type the following command:

DSP VOL,A,100

The letter ‘A’ is the audio port (A-D) and 100 being the audio level (1-255). You can then type DSP VOL to confirm. This setting will remain stored after reboot.